Lead-Free / RoHS 3 Compliant / REACH Compliant
Safe for Use With Electronics
Seals, Bonds, Encapsulates
Resistant to Various Chemicals and Oils
Tested to meet UL Approval Requirements for Horizontal Burn
Tested to meet UL Approval Requirements for Mechanical Adhesion
Flexible, Durable, Non-Degrading
Withstands Moisture, Vibration, Abrasion
Protecting, Sealing and Insulating Corrosion Sensitive Electronic Components and Electrical Materials.
OEM Commercial and Industrial Manufacturing for Flexible Permanent Bonding and Sealing.
Surfaces should be clean and dry. Unscrew cap, cut the tip off. If tooling is required, do so within the first 10 minutes after dispensing. Apply the silicone to surfaces and remove the excess silicone after tooling with a dry clean cloth. Allow the silicone to cure completely. At room temperature, 25C (77F), and 50% relative humidity, the silicone will skin in 10 minutes and fully cure in 24 hours (1/8" bead). The silicone will reach its maximum adhesion in 7 days. Higher humidity accelerates curing.
Meets and Exceeds: ASTM C920, UL Recognized
VOC: VOC Compliant (<3%), Low Odor
Operating Temperature Range: -57C to +204C (-70F to +400F)
Curing Time: 10 min (skin), 24 hours (full cure), 7 days (max adhesion)
Shore A Hardness: 30
Tensile Strength: 250psi
Tear Strength: 30psi
Dielectric Strength: 460 V/mil (18 kV/mm)
Size: 20g Squeeze Tube
Storage and Handling
Store refrigerated or at room temperature 3-25C (37-77F).
This product has no shipping restrictions. Shipping below 0C (32F) or above 25C (77F) for normal transit times by ground or air will not impact this product's stated shelf life.
This product can expose you to Carbon Black and Titanium Oxide, which are known to the State of California to cause Cancer, Birth Defects, or other Reproductive Harm. For more information, go to: www.P65Warnings.ca.gov. These materials
are embedded in the product and are not available as respirable dusts. When used as intended or as supplied, the product will not pose hazards.